sales@menred.com Deutsch Deutsch 中文 中文
SMART O2 G5 Floor Standing Energy Recovery Ventilator

SMART O2 G5 Floor Standing Energy Recovery Ventilator SMART O2 G5 Floor Standing Energy Recovery Ventilator

SMART O2 G5 Floor Standing Energy Recovery Ventilator
MENRED energy and heat recovery ventilation is design for after decoration that you want to install a ventilation, it's a perfect solution to have fresh air for families. A perfect produt usually with high quality components, Germany EBM double inlet centrifugal fan, DAIS membrane core full heat exchanger, EPP whole machine insulation, four operating modes, the ultimate noise elimination, high efficiency filter material.

Features:

1. EBM double inlet centrifugal fan: 146mm diameter, 59 blades, 150mm wide impeller, double air inlet, involute worm gear design, bringing the ultimate in noise control.

2. DC frequency conversion Infinitely variable speed control: 50% Energy consumption of the AC fan, twice width of the wind wheel of an ordinary motor, half fan speed of an ordinary fan, the larger air volume and the lower noise.

3. Antibacterial membrane exchange cores Higher exchange efficiency.The highest efficiency heat recovery, full heat exchange, to meet different seasonal temperature control needs.


Performance Parameters


ModelVoltage(V/Hz)Rated Air Volume(m³/h)Rated Power(W)Noise(dB(A))PM2.5 Filtration EfficiencyWeight(kg)
G5220V/50Hz50013543.999%65

FAQs

Filter replacement Filter replacement
1、When the controller cartridge progress bar shows red, please replace the cartridge in time. 2、Open the middle gland plate of the exchange core in the direction as shown. 3、Take out the cartridge in the direction of the figure and replace it. 4、Put the replaced cartridge into the corresponding slot and cover the exchange core gland. 5、Open the cartridge setting page of the controller and press and hold the cartridge progress bar for 5 seconds to reset the cartridge balance, and the display shows 100% that the reset is successful. Note: Steps 1 and 5 are required for CLS4.0S LCD controller, if you purchase other controllers, please refer to the manual of the controller.
Read More
How many modes of Menred G3 ventilator can be set? How many modes of Menred G3 ventilator can be set?
Energy saving mode: The air volume of exhaust air and fresh air are equal. Default wind speed is low speed. Haze removal mode: The fresh air is high speed, the exhaust air is low speed, and the wind speed shows high speed. Sleep mode: Both fresh air and exhaust air are low speed, wind speed shows low speed. Auto mode: Automatically adjust the airflow level according to the indoor CO2 and PM2.5 concentration. User can set the corresponding value in the setting page. For example, when PM2.5 is set to High > 100 > Medium > 35 > Low and C02 is set to High > 1500 > Medium > 700 > Low, when the air quality sensor detects PM2.4 > 100 and CO2 is between 700 and 1500, the wind speed is high.
Read More
Contact

MENRED Group

Ecomomy Park HQs, Yueqing City, China.

MENRED GmbH

Weisswasser Germany

MENRED Green Building Industrial Park

Oujiangkou New Area,Wenzhou City,Zhejiang China.

MENRED Enviromental Tech Industrial Park

Nanhu District, Jiaxing City, Zhejiang China.